After a few weeksn wait they are finally here.
1mm oversize low comp forged pistons
steel H section rods
arp bolts to match with all the gubins.....
Now just alot more bits to buy
[img][/img]
[img][/img]
[img][/img]
MMmmmmmm, shiny bits
What are they going into? looks serious given the dished and pocketed pistons!
Duratec, supercharged by the sounds of it
How much boost are you thinking of running. Bear in mind you can run about 0.9bar with std compression ratio
not to sure yet, will run a little boost at first then up it as i go along, aiming for 300bhp and torque to match.
It will be a longish build as i am doing everything this time round apart from the head. Only a mild port and polish with some cams and see what
happens.
I dont think i will be disapointed.
Got a dry sump kit to pick up this week and now on the look for a charger.
Loads of nice and expensive ashtrays
Just kidding
lol, old ones will shortly be used as trays