Daddylonglegs
|
| posted on 24/2/09 at 08:02 PM |
|
|
Panhard and Rose Joints
I'm going to order some steel tube to make my Panhard from and think (as mentioned in another Panhard thread in here) I am going to go for Rose
Joint type ends. I'll probably get 20mm 1.6 wall tube but want to be sure I can get the Rose Joint inserts to suit.
Any advice welcome  .
JB
It looks like the Midget is winning at the moment......
|
|
|
|
|
blakep82
|
| posted on 24/2/09 at 08:05 PM |
|
|
i bought threaded inserts from rally design (they are like little top hats) then bought the tube to make sure they were a good tight fit.
________________________
IVA manual link http://www.businesslink.gov.uk/bdotg/action/detail?type=RESOURCES&itemId=1081997083
don't write OT on a new thread title, you're creating the topic, everything you write is very much ON topic!
|
|
|
big_wasa
|
| posted on 24/2/09 at 08:09 PM |
|
|
I used 25mm dia 1.6mm wall and made an insert to fit with an m12 bearing.
|
|
|
Daddylonglegs
|
| posted on 24/2/09 at 09:48 PM |
|
|
quote:
Originally posted by big_wasa
I used 25mm dia 1.6mm wall and made an insert to fit with an m12 bearing.
I did think of using 25mm not really sure if it makes that much difference as I'm only pushing a 1.6 Pinto so not exactly gonna strain the axle
too much!
Unfortunately I don't have the tools or know how to fabricate my own inserts to take spherical joints so I'll have to get the best fitting
ones I can and weld in place.
JB
It looks like the Midget is winning at the moment......
|
|
|
