Steve Hnz
|
| posted on 15/2/04 at 10:32 AM |
|
|
Eccort tie rod taper thread
Whist fiddling with some of the bits & pieces I`m accumulating for my impending build (as you do!) I`ve gone & lost the nut off the top of the
taper of one of my MK2 Escort tie rod ends. Thinking that it would be an easy task to measure it & get another nyloc nut, I got out vernier &
thread gauges & found it was a thread that didn`t correspond to anything on my tapping drilling size chart which contains all the usual suspects.
It appears to be 10mm with a 1mm thread pitch, finer than 10mm fine, definitly not 3/8 unf either. Anyone got any clues for me?
Cheers, Steve. 
|
|
|
|
|
Graceland
|
| posted on 15/2/04 at 12:58 PM |
|
|
M10x1mm on escorts - its a farty size, but any nut and bolt stockist will carry them at a few pence each in stainless too 
|
|
|
