scoobyhunter
|
| posted on 3/10/09 at 07:55 PM |
|
|
rose joint size?
hiya,what size rose/heim joints are people using for a arms ect,for my car engined buggy i had in mind (for chassis side of a arm) circa 16mm thread
and hole size? sound ok?
|
|
|
|
|
flak monkey
|
| posted on 3/10/09 at 07:57 PM |
|
|
1/2" is plenty big enough
Sera
http://www.motosera.com
|
|
|
nitram38
|
| posted on 3/10/09 at 07:58 PM |
|
|
I've used 1/2" UNF on both the F1-2 and MotaLeira.
The F1-2 is 3 years old and done a couple of thousand miles with no problems yet.
|
|
|
scoobyhunter
|
| posted on 3/10/09 at 08:17 PM |
|
|
ok,thanks for prompt replys lads,cheers.
|
|
|
mark chandler
|
| posted on 3/10/09 at 09:55 PM |
|
|
I just got the cheap ones from McGill, 1/2" UNF + the dislocation spacers, these are then an exact fit for standard brackets.
You may also need a tap as once welded the threaded bungs may shrink so will need opening up so get one of these as well.
Its the 2 1/2" bolts to hold it all together that add the costs up.
Regards Mark
[Edited on 3/10/09 by mark chandler]
|
|
|
