omega0684
|
| posted on 23/4/10 at 09:03 AM |
|
|
Prop shaft bolt torque?
what torque should they be at please?
[Edited on 23/4/10 by omega0684]
I love Pinto's, even if i did get mine from P&O!
|
|
|
|
|
matty h
|
| posted on 23/4/10 at 11:56 AM |
|
|
Haynes manual says the following
Propeller shaft to final drive 57-67NM/42-49lbf ft
Centre bearing 18-23NM/13-17lbf ft
This is for non MT75 boxes
Also the propeller shaft bolt are 10.9 grade.
|
|
|
omega0684
|
| posted on 23/4/10 at 01:30 PM |
|
|
cheers matt
I love Pinto's, even if i did get mine from P&O!
|
|
|
phelpsa
|
| posted on 23/4/10 at 05:49 PM |
|
|
Saved me a post, im about to do this 
|
|
|
JoelP
|
| posted on 23/4/10 at 06:25 PM |
|
|
i aim for as tight as possible. Its always a good target, especially as in this case you are unlikely to snap or deform anything. Plus holding the
prop still can be awquard.
|
|
|
