scoobyis2cool
|
| posted on 28/9/04 at 05:34 PM |
|
|
Fuel tank thickness
I'm going over to a company tomorrow to see if they can weld me up a nice ally fuel tank - what thickness of ally shall I ask them to use?
Cheers
Pete
It's not that I'm lazy, it's that I just don't care...
|
|
|
|
|
Viper
|
| posted on 28/9/04 at 05:41 PM |
|
|
1.6 or 2mm is fine, do you know what they are going to charge you?
|
|
|
scoobyis2cool
|
| posted on 28/9/04 at 05:43 PM |
|
|
No idea I'm afraid, why, reckon you could beat them? 
If i get a chance I'll post some details later and maybe you can give me a rough quote
Cheers
Pete
It's not that I'm lazy, it's that I just don't care...
|
|
|
Viper
|
| posted on 28/9/04 at 05:45 PM |
|
|
Is there something special about it?
|
|
|
scoobyis2cool
|
| posted on 28/9/04 at 06:23 PM |
|
|
I need the following features:
baffle inside the tank
swirl pot on bottom with outlet
fuel inlet on top
breather on top
fuel return on top
(possibly a baffle around the breather, it can really spew out fuel under hard cornering)
These are probably quite standard features, I will do a sketch with dimensions tomorrow if that would help
Cheers
Pete
[Edited on 28/9/04 by scoobyis2cool]
It's not that I'm lazy, it's that I just don't care...
|
|
|
