locost7-online.com
|
| posted on 14/1/17 at 04:41 PM |
|
|
Fiat master cylinder pushrods securing
Hi guys, what have you used on your pedal box to hold the pushrods for the master cylinder from falling out? And can I get a rubber boot for my master
cylinder from anywhere? It's Fiat UNO just to confirm.
Locost Xflow 150bhp injected! Sold :-(
Facebook blog https://www.facebook.com/Johns-Tiger-Avon-Build-814223212056368/
PLEASE NOTE THIS MEMBER IS NOT A TRADER.
|
|
|
|
|
SJ
|
| posted on 14/1/17 at 07:03 PM |
|
|
On mine I have a pedal stop that prevents the pedal moving back beyond a certain point but other than that there is nothing else holding the pushrod
in.
|
|
|
locost7-online.com
|
| posted on 14/1/17 at 07:23 PM |
|
|
Thanks for reply, just wondered as I seem to recall I had seen a pic where someone made an aluminium bracket or something similar, was a bit worried
about bouncing the rod out
Locost Xflow 150bhp injected! Sold :-(
Facebook blog https://www.facebook.com/Johns-Tiger-Avon-Build-814223212056368/
PLEASE NOTE THIS MEMBER IS NOT A TRADER.
|
|
|
SJ
|
| posted on 14/1/17 at 08:34 PM |
|
|
The clevis on the pedal holds it at the pedal end and as long as the pedal can't move far enough to let the pushrod fall out I don't see
how you could have a problem.
Stu
|
|
|
