Avoneer
|
posted on 27/2/05 at 08:28 PM |
|
|
Prop Shaft Flange and BEC prop
Hi,
I have two English diffs, both with different prop flange sizes. The best one of the two for a BEC (3.77) has the smaller size flange and the other
(3.89) the larger flange.
Is it easy to get a prop for my BEC with the smaller flange on the end?
Pat...
No trees were killed in the sending of this message.
However a large number of electrons were terribly inconvenienced.
|
|
|
stevebubs
|
posted on 27/2/05 at 08:42 PM |
|
|
Pat,
as you'll most likely be getting the prop made to measure, it shouldn't matter which diff you use - just let them know the diameter / pcd
and you should be fine
Stephen
|
|
Avoneer
|
posted on 27/2/05 at 10:12 PM |
|
|
Cheers Steve.
Didn't know if the manafacturers only made them with the large flange.
How's the car coming on?
Noticed the website is coming on!
Pat...
No trees were killed in the sending of this message.
However a large number of electrons were terribly inconvenienced.
|
|
stevebubs
|
posted on 27/2/05 at 11:18 PM |
|
|
quote: Originally posted by Avoneer
Cheers Steve.
Didn't know if the manafacturers only made them with the large flange.
How's the car coming on?
Noticed the website is coming on!
Pat...
It *may* depend on where you're going but the posts I've seen indicate that so long as you tell them up front exactly what's at each
end then they'll make it up to order.
Website comes on when it's too late to do anything noisy in the garage.
*Finally* managed to get the sump on (just spent 10minutes getting that horrible black Ford Silicon Sealant off my hands)
Fingers crossed it's oiltight!
|
|