markal
|
| posted on 8/4/06 at 03:17 PM |
|
|
Cosworth Diff
Hi, can you just change the stub axle's on a cosworth diff to the smaller flange size 100mm instead of 108mm, or are the internal splines
different. Thanks Alan.
|
|
|
|
|
omega0684
|
| posted on 8/4/06 at 10:59 PM |
|
|
i dont think so, the drive shafts on the cossie are bigger and stronger, but not sure whether this effects the diff splines, are the cv's the
same diameter?
I love Pinto's, even if i did get mine from P&O!
|
|
|
NS Dev
|
| posted on 8/4/06 at 11:44 PM |
|
|
No, the CV's match the flange. Cossies have the "big" 108mm joints, pretty much everything else has the 100mm ones.
Not sure about swapping the stubs over, I don't think that will work though. Liam on here will know.
Retro RWD is the way forward...........automotive fabrication, car restoration, sheetmetal work, engine conversion
retro car restoration and tuning
|
|
|
markal
|
| posted on 9/4/06 at 08:35 AM |
|
|
I can now answer my own question, because i have just done it, you can swap the 100mm from the 108mm ones, provided you use the one's off a
Granada/ Scorpio with a LSD fitted ok, thanks for the replies.
|
|
|
