bigandy
|
| posted on 21/11/06 at 02:22 PM |
|
|
Brake bias bar washers.
Afternoon all.
I need to source some large diamater washers to go between the tube in the brake pedal, and the clevises that go to the two brake master cylinders I
have, to stop the clevises rubbing directly on the brake pedal (the clevises are aluminum)
I'm after a external diameter of around 45mm and an internal diameter to suit a 10mm shaft (although this is not important as I can drill it out
if it is too small). I guess the thickness needs to be around 1mm or so...
Anyone know where I might be able to buy a handful?
Cheers
Andy
Dammit! Too many decisions....
|
|
|
|
|
cryoman1965
|
| posted on 21/11/06 at 02:58 PM |
|
|
Not sure if they do them, but M10 penny washers must be near the dimensions required.
HTH
Cheers Nige
|
|
|
RazMan
|
| posted on 21/11/06 at 04:33 PM |
|
|
I found some stainless repair washers on eBay which were perfect for the job.
Cheers,
Raz
When thinking outside the box doesn't work any more, it's time to build a new box
|
|
|
