blakep82
|
| posted on 23/3/07 at 10:09 PM |
|
|
DIY cortina upright
ok, does anyone know of a standard direct replacement for cortina upright, but with about 2" more distance between the ball joints?
I could go the route of making some custom ones, but not too keen on the idea. problem is the suspension pick up points on the chassis are for izuzu
hubs. cortina ones i guess are shorter, and with the ride height set to absolute minimum the front hubs are about and inch higher than the back axle,
and thats with the front wishbones parallel with the ground. don't want them angled down you see...
any ideas?
[Edited on 23/3/07 by blakep82]
[Edited on 24/3/07 by blakep82]
________________________
IVA manual link http://www.businesslink.gov.uk/bdotg/action/detail?type=RESOURCES&itemId=1081997083
don't write OT on a new thread title, you're creating the topic, everything you write is very much ON topic!
|
|
|
|
|
blakep82
|
| posted on 23/3/07 at 11:46 PM |
|
|
what about granada uprights? will they work instead? are they any 'taller'?
________________________
IVA manual link http://www.businesslink.gov.uk/bdotg/action/detail?type=RESOURCES&itemId=1081997083
don't write OT on a new thread title, you're creating the topic, everything you write is very much ON topic!
|
|
|
blakep82
|
| posted on 25/3/07 at 02:20 PM |
|
|
no?
________________________
IVA manual link http://www.businesslink.gov.uk/bdotg/action/detail?type=RESOURCES&itemId=1081997083
don't write OT on a new thread title, you're creating the topic, everything you write is very much ON topic!
|
|
|
