plantman
|
 posted on 30/6/08 at 09:52 AM |
|
|
Drive shafts 4x4
i am just about to bolt my 4x4 driveshaft to my diff etc.
Is there a supposed to be a gasket between all the flanges to stop the grease coming out?
cheers
|
|
|
|
|
Paul TigerB6
|
| posted on 30/6/08 at 09:57 AM |
|
|
the grease should be on the CV joints under the rubber boots and not between the flanges. I'd always use a smear of copper grease on the flange
faces though, but no gasket as far as i am aware.
|
|
|
mcerd1
|
| posted on 30/6/08 at 11:11 AM |
|
|
I've never found any gasket on any I've dismantled, but the haynes book recomments a little sealant between the joint and the cover (F + G
above)
so I guess the same could apply at the other side of the joint, but a little grease should be enough
[Edited on 30/6/08 by mcerd1]
|
|
|
plantman
|
| posted on 30/6/08 at 02:11 PM |
|
|
Oooo Lovely , thank you very much I'll put it all together tonight and we will be rolling
thank you
|
|
|
