AndyG
|
| posted on 24/8/17 at 10:08 AM |
|
|
Fury Ball Joints
Hi,
I have a fury which needs the front lower ball joint replacing I have spoken to Fury who are struggling to get hold of these does anyone know where I
can track some down at short notice as I have a road trip to Prague in a couple of weeks therefore I need to get the parts asap. Any help would be
much appreciated.
Thanks
Andy
|
|
|
|
|
adithorp
|
| posted on 24/8/17 at 12:41 PM |
|
|
They're Sherpa/Transit drag link ends (r/hand thread, off-side). Should be available from a good motor factor.
"A witty saying proves nothing" Voltaire
http://jpsc.org.uk/forum/
|
|
|
AndyG
|
| posted on 24/8/17 at 07:47 PM |
|
|
Thanks for the reply do you know what year transit they are from as there seemed to be quite a bit of difference from different years. Thanks
|
|
|
adithorp
|
| posted on 24/8/17 at 08:18 PM |
|
|
Think it's this one... https://car-part-info.com/quinton-hazell-qd1117rht/
"A witty saying proves nothing" Voltaire
http://jpsc.org.uk/forum/
|
|
|
AndyG
|
| posted on 24/8/17 at 08:32 PM |
|
|
Thanks much appreciated.
|
|
|
obfripper
|
| posted on 24/8/17 at 09:03 PM |
|
|
Quinton hazel QR1774RHT is the one to replace striker/phoenix/fury/stylus lower arm balljoints where an escort or capri upright is used.
Depending on the design of the replacement, some modification of the taper shank may be needed to allow the taper to fully seat.
Dave
[Edited on 24/8/17 by obfripper]
|
|
|
adithorp
|
| posted on 25/8/17 at 09:18 AM |
|
|
quote:
Originally posted by obfripper
Quinton hazel QR1774RHT is the one to replace striker/phoenix/fury/stylus lower arm balljoints where an escort or capri upright is used.
Depending on the design of the replacement, some modification of the taper shank may be needed to allow the taper to fully seat.
Dave
[Edited on 24/8/17 by obfripper]
Think that could well be the one. The one I linked to is M20x1.5 and the above is UNF which I seem to remember is whats on.
"A witty saying proves nothing" Voltaire
http://jpsc.org.uk/forum/
|
|
|
AndyG
|
| posted on 27/8/17 at 10:28 AM |
|
|
I purchased one of these but as you say it needs a but if work to get it to fit. Is this just a case of re-threading it with a unf.
Also I need to purchase some bushes but Fury are struggling to get these do you know of anywhere you can the bushes I need the 4 by the diff replacing
but ultimately I would want to replace all of them.
|
|
|
