dan__wright
|
| posted on 2/4/09 at 03:18 PM |
|
|
Suspension setup in south oxfordshire
as above, any suggestions / recommendations?
im in the didcot / abingdon area, car needs a full geometry / corner weight session.
looking at owen developments (anyone used them - any good?) but its hard to get hold of someone / a time to have it done.
any other suggestions?
|
|
|
|
|
pewe
|
| posted on 2/4/09 at 04:01 PM |
|
|
Try Jamie at Jtech in Dunsden nr. Reading 0118 9479555. Set my F27 up and transformed it!
Used to race a Sylvia and worked for one of the South's top race shops so knows his onions.
Cheers, Pewe
|
|
|
Johneturbo
|
| posted on 2/4/09 at 04:12 PM |
|
|
Cool, i'm at that stage of needed it properly set up too
i didn't know there was anyone localish
|
|
|
bimbleuk
|
| posted on 4/4/09 at 06:20 AM |
|
|
Brian at Mech Motorsport in Cheltanham (01242) 243385 can do a full corner weight and laser alignment. Very friendly and very experienced at setting
up all manner of race/road cars.
If you feeling a bit more flush then speak to Neil at Corinium Motors in Cirencester. He can do the corner weighting and alignment (more traditional
methods). You can arrange to meet at a track day or test day and do the whole lot at the track. Again lots of experience setting up circuit cars
etc.
Mech Motorsport
Corinium Motorsport
|
|
|
bimbleuk
|
| posted on 4/4/09 at 06:22 AM |
|
|
Oh and Mech Motorsport can do a dyno run and any engine tweaks while you're there.
|
|
|
