cliftyhanger
|
| posted on 9/3/11 at 11:26 PM |
|
|
MGF hub bolt size
Need to strip some MGF driveshafts, but haven't a socket large enough. Anybody happen to know the size I need? looks about 1 1/4" in old
money with teh verniers
Cheers
Clive
|
|
|
|
|
Peteff
|
| posted on 10/3/11 at 11:12 AM |
|
|
That would be about 32mm in new money.
yours, Pete
I went into the RSPCA office the other day. It was so small you could hardly swing a cat in there.
|
|
|
rusty nuts
|
| posted on 10/3/11 at 07:11 PM |
|
|
IIRC the old Metro hub nut was 1 5/16" , as the MG uses a lot of Metro parts its likely to be the same . Should be easy enough to measure
|
|
|
.jpg)
