johnnybizzle1986
|
| posted on 30/11/17 at 01:54 PM |
|
|
Sierra ignition barrel
Hi Guys,
I dont have a key with my sierra steering column, is there a way of removing the barrel so that I can install a new one
Regards Jon
|
|
|
|
|
nick205
|
| posted on 30/11/17 at 02:05 PM |
|
|
Don't know, but what about one of these...
|
|
|
Daf
|
| posted on 30/11/17 at 02:24 PM |
|
|
quote:
Originally posted by johnnybizzle1986
Hi Guys,
I dont have a key with my sierra steering column, is there a way of removing the barrel so that I can install a new one
Regards Jon
Yes... but you need the key to do it!
http://www.fordmanuals.org/page-1684.html
You might be able to achieve the same thing by hammering a big screwdriver in and turning it to position 1 - but I don't know what else would
get trashed in the process.
|
|
|
madteg
|
| posted on 30/11/17 at 02:33 PM |
|
|
I drilled mine out but its a right pain in the ar-e
|
|
|
chris
|
| posted on 30/11/17 at 04:41 PM |
|
|
arent the seirra barrels just clamped to the column and wiring three wires or four
i got a new ignition barrel from CBS and mounted it to dashboard
|
|
|
ian locostzx9rc2
|
| posted on 30/11/17 at 05:43 PM |
|
|
Theres a little pin you need to drill out then you can release the lock barrel from the holder .
|
|
|
johnnybizzle1986
|
| posted on 30/11/17 at 08:38 PM |
|
|
Ok
Thanks guys il give it a whirl this weekend
Regards
|
|
|
ianhurley20
|
| posted on 30/11/17 at 11:05 PM |
|
|
Forgive me but I seem to remember being told that if i screwed in the threaded end of a slide hammer then slid the weight back I only needed a
screwdriver to start and drive the car - or maybe that was several years ago 
|
|
|
rusty nuts
|
| posted on 1/12/17 at 04:58 PM |
|
|
You may find any Ford key of the type Sierras used might allow you to remove the barrel ?
|
|
|
.jpg)
