Shooter63
|
| posted on 10/2/18 at 09:35 AM |
|
|
Wheel clearance
I've been looking for some 13" wheels with a half decent offset without any success so I think I'll have to bite the bullet and
order up some new ones, not sure which yet but probably revolutions, image, force etc while I know how to work out the offsets etc what I need to
know is how much clearance should I allow, I'm thinking 10mm would be ok, what are people's thoughts
Shooter
|
|
|
|
|
steve m
|
| posted on 10/2/18 at 10:09 AM |
|
|
I have 1mm clearance between the inner wheel weight and the brake caliper, never had an issue yet
steve
[Edited on 10/2/18 by steve m]
Thats was probably spelt wrong, or had some grammer, that the "grammer police have to have a moan at
|
|
|
Shooter63
|
| posted on 10/2/18 at 10:42 AM |
|
|
Thanks but I'm really talking about the clearance to the suspension arms on the rear axle
Shooter
|
|
|
CosKev3
|
| posted on 10/2/18 at 12:55 PM |
|
|
quote:
Originally posted by Shooter63
Thanks but I'm really talking about the clearance to the suspension arms on the rear axle
Shooter
Perhaps you should have said that in the opening post then!!!!! 
Lots of Westfields with wide 13 inch rims on the rear run a few mm''s of clearance to the bottom hub mounting bolts without issue,I think
you can reduce your 10mm to 5mm with ease imo
|
|
|
