rdodger
|
| posted on 2/5/21 at 04:12 PM |
|
|
Brake pressure switch
Just a quick one
I am about to add a brake pressure switch. I expected it to have a thread that would bottom in the fitting like a brake pipe. It doesn't, though
as you screw it in it goes tight and looks like a tapered thread.
So is it normal for it to be tapered thread and is it best practice to add some sort of sealer or not?
Thanks
|
|
|
|
|
adithorp
|
| posted on 2/5/21 at 06:09 PM |
|
|
Both taper and straight are available. It should seal on its own. You shouldn't use anything on it as (a) it can get in the pl8ne and cause
issues (b) the switch earth's through the threads and it could insulate that.
"A witty saying proves nothing" Voltaire
http://jpsc.org.uk/forum/
|
|
|
rdodger
|
| posted on 2/5/21 at 06:14 PM |
|
|
Ok thanks Adi
|
|
|
