SALAD
|
| posted on 6/3/06 at 05:33 PM |
|
|
Suspension Powdercoating
I have made contact with beige badger, my new powdercoating contact. I have to drop off the consignment after 19:00 hours to avoid the guards. I may
not make it back from this one....... ANYWAY....how much do you think is a good price for powdercoating - wishbones, trailing arms, panhard rod and di
dion axle? Prepared first then coated. Beige badger is doing them for me 'on the side' so will be for cash.
|
|
|
|
|
flak monkey
|
| posted on 6/3/06 at 06:08 PM |
|
|
£25 for blasting and £25 for coating is what I was quoted for those bits by a mate (cash in hand). But I bought a compressor and spray gun instead!
Sera
http://www.motosera.com
|
|
|
SALAD
|
| posted on 6/3/06 at 06:29 PM |
|
|
So £60 for this guy to do isn't too bad then, I only met him today! Dropping the bits off tonight at his work and he will do them over the next
few days.
(I have confidence he knows what he's doing)
|
|
|
indykid
|
| posted on 6/3/06 at 07:03 PM |
|
|
sounds reasonable.
i got a prepped roll bar and cycle wing stays done for £15. it was the stays that cost most, as "they werry fiddly" says he, in his best
broken english.
cash again, but i think that's all they deal in. good job though, and it never chipped.
tom
|
|
|
