Hi chaps,
brought some copy roadster 7 type seats of the flea bay recently.
Collected them from the guy, i also bought a set of low profile seat runners.
just had a look at the items
The bottom of the seat is just the tubular sections of the main seat, do i have to drill holes in these tubes to suit my seat runners of do i need some sort of sub frame for each my seats.
cheers

The Cobra Roadsters I have have a welded in nut in the corners (hidden under the fabric) If you press your finger into the fabric you can feel the indent where the nut is. Then with some careful work with a stanley knife you have your bolt holes accessible!

Mark

Thanks Mark,
you are top bannana, must have been doing 'man looking ' as my better half says !!!!!!!!!!!!!!!
Found them just as you described
cheers
John