Board logo

Which fb seats fit a raw?
shaun fulcrum - 27/12/08 at 04:53 PM

Hi everyone,
Any ideas? I bought a pair from Triton, amazing seats! but they wont fit!!

The seats need to be 350mm max at the front edge and 370mm at the rear.

Help!

Thanks,
Shaun

fishywick - 27/12/08 at 05:13 PM

Don't know anything about them but I have considered these......

http://www.jkcomposites.com/7%27s-dimensions-page.html

I am using the foam in a bag type at the moment but keep looking at other possibilities. These JK ones look to be one of the few that might fit.

Steve

scootz - 27/12/08 at 06:55 PM

I've used those before... very good!

marmot0 - 27/12/08 at 08:27 PM

bought mine from jk composites
http://www.jkcomposites.com/
very nice light weight seats and drop straight in the striker

shaun fulcrum - 27/12/08 at 10:35 PM

Cheers guys,

I think I sat in 1 of your seats Marmot, when your car was at andys. Never new where they were from though.

All very helpful and appreciated.

Thanks again
Shaun

jeffw - 28/12/08 at 05:01 PM

I have a set of Tillett seats in my Phoenix (B3.5 on the website)

bigfoot4616 - 28/12/08 at 06:15 PM

quote:
Originally posted by marmot0
bought mine from jk composites
http://www.jkcomposites.com/
very nice light weight seats and drop straight in the striker


am thinking about some of these, using the measurements from there site i wasn't quite sure if they would fit at the front. allthough i may not of been measuring in the right place

shaun fulcrum - 28/12/08 at 08:13 PM

I think most grp seats finish up at the cross member in the floor, which on mine measured 354mm, so a tight fit but 2mm either side is all you need ;]

Triton - 30/12/08 at 10:56 AM

Shaun,
Sent you an email meduck.

Mark

bigfoot4616 - 31/12/08 at 10:10 PM

quote:
Originally posted by shaun fulcrum
I think most grp seats finish up at the cross member in the floor, which on mine measured 354mm, so a tight fit but 2mm either side is all you need ;]


no cross member on mine. having looked at some pics that is roughly where i have measured at. still about 15mm to narrow.


my tunnel does look wider than some i've seen



anyway spoke to jk today and will be going down to pick up a pair in a couple of weeks, i will make them fit somehow