Looking at replacing my Cobra Roadster seats with some GRP seats.

Can anyone tell me the dimensions/offset of the Cobra seat bolts?

I've taken a crude measurement of 33cm front to back and 29cm side to side with the seats bolted in the car.

However, if a kind LCB who hasn't fitted their Cobra seats yet could give me a more accurate measure it would be apprieciated.

I want to retain the current runners and dont fancy drilling more holes in the floor if I can help it.

If someone hasn't come back to you by the time I get out to the barn to measure mine I'll pop it on here

JB

JB, If you can get me the measurements that would be great

Right, just measured the bolt holes:

Front to back - 330mm

Left to right - 290mm

These are as near as I can measure but should be OK for your needs.

just to be sure, mine are the Cobra Roadsters (the comfy ones )

HTH

JB

JB - Thanks. They match the crude measurements I got.

I'm going lightweight with my seats - following a winter without any exercise I'm the comfy one now.