Board logo

H section rubber extrusion
cd.thomson - 5/12/09 at 08:55 PM

Hi Guys,

has anyone tried to source some of this? I want to cut my tunnel in half (widthways) to allow easier access and want to "conceal" the cut by fitting a strip of H section rubber.

The slots should be thick enough for grp, something like 5-6mm and the total width of the strip should be about 20mm

anyone know a supplier?

austin man - 5/12/09 at 09:04 PM

what about the strip that they use in the backs of wardrobes to join the hardboard, would that do the trick??

Dingz - 5/12/09 at 11:35 PM

Baines
Try these people.

Blackbird Rush - 6/12/09 at 07:46 AM

quote:
Originally posted by cd.thomson
anyone know a supplier?


Here you go...

Wollies linky

Or you could just run some gaffa tape accross the gap (assuming your going to carpet over it...

Mal - 6/12/09 at 09:50 AM

Another one is Seals Direct.