Board logo

L-profile rubber trim
rodgling - 12/3/11 at 11:34 PM

Anyone got any idea where I can find some? IVA want me to trim the edge of my centre tunnel (this was one of my failures) - I could no doubt improvise with some other shape but if I can find some proper L-profile trim, that would be ideal. Surely someone must make it?

(by L-profile, I mean that in cross-section it would be a sort of L shape, about 10 mm each side)

[Edited on 12/3/11 by rodgling]


dave-69isit - 13/3/11 at 02:58 AM

how about draft excuding its rubber and can glue it to any shape n remove after iva just an idea


Flamez - 13/3/11 at 04:58 AM

Use aluminium extrusion and the profile is called hockey stick..


rusty nuts - 13/3/11 at 01:34 PM

Check out the Woolies trim site, loads of stuff on there