Board logo

your IVA dash and your finished dash
mk85 - 11/1/15 at 11:11 AM

So reading the iva rules i see there a pain in the arse. And i see afew people have changed theres after the iva. What have you used for your iva dash board without drilling holes into a nice carbon dash.

Before and after picture please

CosKev3 - 11/1/15 at 11:15 AM

If you look in the BEC section at zx12dugs MK you will see his IVA dash,MDf covered with foam and vinyl.

Really good job.

[Edited on 11/1/15 by CosKev3]

CosKev3 - 11/1/15 at 11:18 AM

http://www.locostbuilders.co.uk/forum/21/viewthread.php?tid=195535

mk85 - 11/1/15 at 11:35 AM

nice finish on that

jollygreengiant - 11/1/15 at 12:43 PM

Similar to what I did for SVA, but, it is about to get re-worked.

40inches - 11/1/15 at 02:05 PM

IVA Dash
Description
Description

Post IVA Dash
Description
Description

FuryRebuild - 11/1/15 at 02:46 PM

40inches - that is nice work.

loggyboy - 11/1/15 at 03:01 PM

Make the whole dash replaceable? Fit some cheap ply with self adhesive vinyl layer then dril/cut to suit iva layout. Then replace whole carbon unit post IVA?

[Edited on 11-1-15 by loggyboy]

The Black Flash - 6/2/15 at 02:10 PM

Which particular bit is causing you a pain? I didn't really find the IVA bothered me too much in the dash department. There may be an easier way around it than making a whole special dash.