Really struggling here as attempting to attach a picture but just bumbling about like Boris

I have uploaded to picture gallery but how to I attach it to my posting?

[Edited on 28/6/20 by shortcircuit]
[img][/img]

[Edited on 28/6/20 by shortcircuit]

Copy and paste the pg code above the photo

Thanks I eventually got there. Still lost, will this strip meet IVA?

The dash needs a radius edge at the bottom, not sure of the exsactly ratio but something like 20mm

Jason

Thanks for reply. IVA "radius of curvature not less than 19mm or 5mm and be covered with a non-rigid material," I was hoping the trim would meet the 5mm requirements and was looking for any experience.

The IVA Manual IVA references a non rigid material:

" A "non-rigid material" is a material which has a hardness of less than 50 shore A. For the purposes of this examination it will be deemed to be a
material which is capable of depression under thumb pressure and when deformed retains a degree of protection against contact with any structure which it is covering and when released returns to its original form."

50 shore A is about equivalent of a rubber stamp - you can do a quick google to get other comparisons.


It's not to say it could not pass - but reading the description I's say the trim would not compress enough under a thumb pressure
Cheers

Ian

[Edited on 29/6/20 by mackei23b]

Thanks very much for that informative reply. I am aware of other trims that may be suitable so will continue a search for a solution other than welding something on.

How can I add a photo?

""Copy and paste the pg code above the photo""

Where do find that?