Board logo

Seat Mounting
GaryM - 18/9/05 at 07:52 AM

Hi Guys

Has anyone passed SVA with their seats/runners bolted directly through a 2mm thick steel floor?

Cheers
Gary

[Edited on 18/9/05 by GaryM]


Hornet - 18/9/05 at 08:38 AM

Yup I did...
Cheers


Triton - 18/9/05 at 09:40 AM

GaryM,
I thought i mentioned that when i was at Whilton?....but then it was the morning after and with all those looney strokers hammering around i probably dreamt it!!!

If you are worried make up some big washery things to spread the load under the floor

Cheers
Mark


GaryM - 18/9/05 at 10:52 AM

The SVA manual mentions 100mm x 100mm x 4mm spreader plates but I'm not sure of this only applies to pedestal seats (whatever they are)?