ive got my new seats now but i need some advise on fitting .
as the bum part is lower than the base of seat i guess you have to fit some kind of metal tubing to rasie the seats up higher.

ive got runners for the drivers seat (comes in two bits) or can someone recommend a different runner that is easy to fit and works good
thanks
simon

the way i did it without runner (but should work the same) is use 4 pieced of 50 x 50 x 3 aliminum angle. 2 for each side bolted back to back to creat a Z section. This means u can alter the angle of the seat also with multiple holes on the vertical part of the faces which make the Z section. It also lifts the seat so the bottom lower part doesnt hit the floor.

Really need a pic to show but i havent got one at the mo.

Advice on our website...

HERE

Feb 1st...

Steve

erm... ignore my advice. that guys not only got pics but his own website lol

OR big repair washers

quote:

---

Originally posted by Moorron
erm... ignore my advice. that guys not only got pics but his own website lol

---