Hi
I have a carbon fibre effect dashboard which I do not want to use until after the SVA. Therefore, as a tempory measure would it be acceptable (for SVA) to build a dash from 6mm ply covered with foam backed vinyl and a lower trim (taken from the the door shut of the Sierra) along the bottom to give it a radius. The switches and dials will be placed behind the steering wheel.
Cheers
Barry

Yep, exactly what I did.

Rich.

As long as it meets SVA requirements you can do what you like afterwards!

do you have to have a soft dash for the SVA then as i was going to have a carbon afec dash in my car will this not pass then ???

It doesn't have to be padded but the edge / radius requirements are more stringent it its solid.