shaun fulcrum
|
| posted on 27/12/08 at 04:53 PM |
|
|
Which fb seats fit a raw?
Hi everyone,
Any ideas? I bought a pair from Triton, amazing seats! but they wont fit!!
The seats need to be 350mm max at the front edge and 370mm at the rear.
Help!
Thanks,
Shaun
|
|
|
|
|
fishywick
|
| posted on 27/12/08 at 05:13 PM |
|
|
Don't know anything about them but I have considered these......
http://www.jkcomposites.com/7%27s-dimensions-page.html
I am using the foam in a bag type at the moment but keep looking at other possibilities. These JK ones look to be one of the few that might fit.
Steve
|
|
|
scootz
|
| posted on 27/12/08 at 06:55 PM |
|
|
I've used those before... very good!
|
|
|
marmot0
|
| posted on 27/12/08 at 08:27 PM |
|
|
bought mine from jk composites
http://www.jkcomposites.com/
very nice light weight seats and drop straight in the striker
|
|
|
shaun fulcrum
|
| posted on 27/12/08 at 10:35 PM |
|
|
Cheers guys,
I think I sat in 1 of your seats Marmot, when your car was at andys. Never new where they were from though.
All very helpful and appreciated.
Thanks again
Shaun
|
|
|
jeffw
|
| posted on 28/12/08 at 05:01 PM |
|
|
I have a set of Tillett seats in my Phoenix (B3.5 on the website)
|
|
|
bigfoot4616
|
| posted on 28/12/08 at 06:15 PM |
|
|
quote:
Originally posted by marmot0
bought mine from jk composites
http://www.jkcomposites.com/
very nice light weight seats and drop straight in the striker
am thinking about some of these, using the measurements from there site i wasn't quite sure if they would fit at the front. allthough i may not
of been measuring in the right place
|
|
|
shaun fulcrum
|
| posted on 28/12/08 at 08:13 PM |
|
|
I think most grp seats finish up at the cross member in the floor, which on mine measured 354mm, so a tight fit but 2mm either side is all you need ;]
|
|
|
Triton
|
| posted on 30/12/08 at 10:56 AM |
|
|
Shaun,
Sent you an email meduck.
Mark
My Daughter has taken over production of the damn fine Triton race seats and her contact email is emmatrs@live.co.uk.
www.tritonraceseats.com
www.hairyhedgehog.com
|
|
|
bigfoot4616
|
| posted on 31/12/08 at 10:10 PM |
|
|
quote:
Originally posted by shaun fulcrum
I think most grp seats finish up at the cross member in the floor, which on mine measured 354mm, so a tight fit but 2mm either side is all you need ;]
no cross member on mine. having looked at some pics that is roughly where i have measured at. still about 15mm to narrow.
my tunnel does look wider than some i've seen
anyway spoke to jk today and will be going down to pick up a pair in a couple of weeks, i will make them fit somehow
|
|
|
