minimum radius for transmission tunnel stuff

Not logged in [Login - Register]

LocostBuilders » Forum » Interior & Seating » minimum radius for transmission tunnel stuff

Power Tools at MachineMart.co.uk

Printable Version | Subscribe | Add to Favourites

panichat

Contributor

Posts 252
Registered 15/11/06
Location Worcestershire
Member Is Offline

Photo Archive Go!

Building: Locost - by the book, IVA passed in 2010!

posted on 24/1/09 at 08:06 PM

minimum radius for transmission tunnel stuff

I'm making the upper panel for the transmission tunnel and want to accomodate a few raised areas. Is there a minimum radius requirement associated with this area?
Thanks
Dave

[Edited on 24/1/09 by panichat]

mistergrumpy

Apparently!

Posts 4193
Registered 17/8/06
Location Bolton, Lancashire
Member Is Offline

Photo Archive Go!

Building: Up trust to use my ZX9 Locost

posted on 24/1/09 at 08:32 PM

There should be I suppose but I've got a on piece tunnel that was bent on a machine so the edges are very tight but SVA man didn't bother. Matbe its because they're not sharp.

ReMan

Country Member

Posts 7093
Registered 22/5/04
Location Leicestershire, Burr Beige
Member Is Offline

Photo Archive Go!

Building: Nothing, just collecting cars!

posted on 25/1/09 at 12:26 AM

I believe it's 2.5mm radius on interior contactables, which squre chassis tubes just pass

panichat

Contributor

Posts 252
Registered 15/11/06
Location Worcestershire
Member Is Offline

Photo Archive Go!

Building: Locost - by the book, IVA passed in 2010!

posted on 25/1/09 at 03:41 AM

Thanks (nt)

LocostBuilders » Forum » Interior & Seating » minimum radius for transmission tunnel stuff

All content © 2001-16 LocostBuilders. Reproduction prohibited
Opinions expressed in public posts are those of the author and do not necessarily represent
the views of other users or any member of the LocostBuilders team.
Running XMB 1.8 Partagium [© 2002 XMB Group] on Apache under CentOS Linux
Founded, built and operated by ChrisW.