t.j.
|
| posted on 12/1/08 at 07:52 PM |
|
|
anchorage strenght minimum thickness
HI,
Q: My nose off the sierra differential wil be mounted in a triangulation at the rear of the tunnel.
This triangulation will also contain the anchorage nut for the seat-belt.
What thickness would you use?
4 mm? or could 3 mm be sufficient?
thnx
Please feel free to correct my bad English, i'm still learning. Your Dutch is awfull! :-)
|
|
|
|
|
tks
|
| posted on 12/1/08 at 08:01 PM |
|
|
it depends on how the forces will be acting on the sheet.
if its sideways you will need thicker sheet then if its lenght wise..
The above comments are always meant to be from the above persons perspective.
|
|
|
tks
|
| posted on 12/1/08 at 09:11 PM |
|
|
if it isn't much sheet i would use 4mm.
also its different if the forces are pushing on the sheet or pulling.
pulling=thinner
pushing = thicker
tks
The above comments are always meant to be from the above persons perspective.
|
|
|
t.j.
|
| posted on 12/1/08 at 09:27 PM |
|
|
As it will be the lower behind the seat the forces will be in lenght, so in the triangulation and not sideways
I will use 4 mm for safety. I don't want safety-belts which can't do their job.
Thx
[Edited on 12/1/08 by t.j.]
Please feel free to correct my bad English, i'm still learning. Your Dutch is awfull! :-)
|
|
|
