edspurrier
|
| posted on 17/10/07 at 10:48 AM |
|
|
Vinyl edge trimming
AM trimming cockpit. I'd like to butt the vinyl from the against the edge of a neigbouring aluminium panel - both on the same level against a
panel behind.
Is there a neat trick to cut vinyl edges against a panel edge? I've tried running a thin blade against the edge of the aluminium, but
there's always a tiny but obvious gap.
Thanks
|
|
|
|
|
caber
|
| posted on 17/10/07 at 12:09 PM |
|
|
Fold the vinyl over the edge of the panel and glue it down. You can get piping from woolies trim I am using cream piping against red, this can be
glued or stappled onto one edge to fill the join.
Caber
|
|
|
