The Doc
|
posted on 12/1/08 at 06:37 PM |
|
|
Dellortos Again
Just got round to trying my nice shiny Dellortos onto the inlet manifold only to find that they fit on to the studs OK but the linkage does not meet
up. They're too far apart.
Is the Weber IM different spacing from the Dellorto?
Mike
|
|
|
Peteff
|
posted on 12/1/08 at 08:13 PM |
|
|
I think it's more likely your carbs came from something different. Can you take the balance linkage off and extend it so it reaches the other
carb?
yours, Pete
I went into the RSPCA office the other day. It was so small you could hardly swing a cat in there.
|
|
JJM
|
posted on 12/1/08 at 08:32 PM |
|
|
Yup different spacings for different applications-you can either buy a new extended 'lever' or remove yours and weld a small piece on-this
is how i did mine.
|
|