I'm having a garage clearout and have a few bits to sell and thought that I would offer them here before facing the wrath of eSkip. They are all located near York but I may be able to deliver/meet you somewhere as I tend to get around the country a bit: -
Ally Cat Wheels
Two pairs, both 6" x 14", ET16 offset in pretty good, straight condition. One pair have a pcd of 108mm (Ford etc.) and the other 100mm (Vauxhall, Triumph etc.). They were taken off my old Striker when I changed to Ford front uprights and 13" wheels. They would benefit from a polish and repaint as some of the paint is lifting, with a bit of minor corrosion underneath (one pic shows the about the worst of it). Make me an offer for either the set of four or per pair.
100mm pcd wheels: -
VX Wheels
VX2
The worst of the corrosion: -
VX corrosion
108mm pcd wheels: -
Ford Wheels
Weber carbs
Two Weber downdraught carbs, one is a DVAG 32 (the one not on the manifold), the other is unknown as I can't find any markings and would probably only be good for spares.
I think that I once used the DGAV 32 on my old 1300 x-flow and it seemed to be ok, though has been sat in the garage for the last few years. Again, make an offer.
Carbs: -
Carb1
DGAV 32
Other Weber
Chopped Zetec sump
This belongs to a friend and was bought with a Zetec, but I couldn't tell you which so I don't know which one it will fit. It has been chopped and baffled but it wouldn't fit in his Cateringvan and so he ended up buying one from elsewhere. I don't know if it leaks but the welds look ok. Again, make an offer if you're interested!
Sump: -
Sump1
Sump2
Sump3
Sump4
Sump5
