Seven_Monkey
|
posted on 22/4/10 at 08:45 AM |
|
|
Oil Galley Plugs
Hi all, the oil galley plugs on my Xflow block will not budge - has anyone got any tips for removing them?
I'm trying to rebuild the engine and I want to renew these plugs and clean out the galleys.
Thanks
Rich
Build Thread - http://www.locostbuilders.co.uk/viewthread.php?tid=134121
|
|
|
snapper
|
posted on 22/4/10 at 10:14 AM |
|
|
If they are screw in then some heat always helps
I eat to survive
I drink to forget
I breath to pi55 my ex wife off (and now my ex partner)
|
|
MakeEverything
|
posted on 22/4/10 at 10:29 AM |
|
|
If youre clearing out the opilways anyway, then how about drilling some holes across the centre to weaken it, and use a hammer and cold chisel to bend
it and get them out?
Kindest Regards,
Richard.
...You can make it foolProof, but youll never make it Idiot Proof!...
|
|
rusty nuts
|
posted on 22/4/10 at 06:47 PM |
|
|
Try using a drift down the center of the hexagon and give each plug a few good clouts then using a good correct size Allen key to undo them . I used a
bit of extra leverage when I did mine as they were pretty tight.
|
|