for these...
Darren told me he could supply the relevant tube but I was wondering if I'll be able to pick some up locally - otherwise arrange to get some at stoneleigh.
Cheers
G
As I hav'nt got the items where I am at the moment does anyone know the id and od of the tube required when using the in-situ top camber
adjusters?
for these...
Darren told me he could supply the relevant tube but I was wondering if I'll be able to pick some up locally - otherwise arrange to get some at
stoneleigh.
Cheers
G
The camber adjusters measure 21.75mm on the OD. So are designed to fit in tube with a nominal bore of about 22mm. I think the wall thickness of the
tubes on the wishbones is about 2.5-3mm but i can be sure as I dont have them here with me.
Cheers,
David
Cheers (again 
)