Can anyone tell me the thread/bolt size for the axle where the panhard rod connects. Since painting i cant seem to get anything in the hole
Steve.

1/2" or M12 carnt remember which

[Edited on 18/6/06 by Gav]

its m12. i know because its a 1/2" rodend and i had to pack it out to fit nicely with the m12 bolt. there is an old thread somewhere when i posted about it..

if you painted it you might need to run a tap through it or try a high grade bolt with some oil to clean the thread up.

Ned.

ps http://www.locostbuilders.co.uk/viewthread.php?tid=38827

[Edited on 18/6/06 by ned]

Many thanks. Cant get a tap in 'cos its on the car so ill try the bolt thing next.
Thanks again.
Steve.

Ned, i think i have just forced an m12 bolt into the the wrong hole. That was bloody hard work
Its fits now anyway