Cut some vents in my bonnet today:

Vents cut today
More pics in '25 June 2009' folder of archive.
John.

Looks good

Yes, I'm very pleased with the result.
I dread to think how it would have turned out using pre-Dremel techniques.


Impossible Limerick competition.........

'A wonderful tool is the Dremel,
...'

nice, i would have never through about doing that desing, but it looks nice.

stuart

nice work, given me some ideas

arrgghhhh ... here I go again, frothing at the mouth whenever I see expanded mesho or holed mesh arrgggjhhhhhhh ....

you might as well reap the full benefit and fit wire mesh and not block up the vents with unnecessary metal.

apart from that, good job.

now i need to lie down in a quiet dark place ....

Did you have an unfortunate experience with mesh, 02?
I'll see how it goes - it's only taped in pro tem - and the pierced stainless was the only 'suitable' material to hand.
Is 02GF74 a Lt-wt LR?

quote:

---

Originally posted by 02GF74
arrgghhhh ... here I go again, frothing at the mouth whenever I see expanded mesho or holed mesh arrgggjhhhhhhh ....

you might as well reap the full benefit and fit wire mesh and not block up the vents with unnecessary metal.

apart from that, good job.

now i need to lie down in a quiet dark place ....

---