Afternoon all,
I've found that the nearside push-in sierra driveshaft I have has the wrong thread on the stub axle i.e. the nut turns to the back rather than
the front of the car (no idea how this has happened). I have got a stub axle with the correct thread on it so want to swap this for the incorrect
one.
Problem arises that the "right" stub axle came off a driveshaft where the metal casing cover around the joint was smaller (in diameter) than
the one that is on the driveshaft that I am putting it on. Before I order a new casing and cut the one off, is this going to be an issue when I come
to fit it together?
I have checked the number of splines and they are the same so not sure why they are two different sizes.
Cheers,
mads
[Edited on 16/9/12 by mads]
The push fit hubs are handed
Nearside right hand thread
Offside left hand thread
Both shafts are different lengths
The simple option is to buy a secondhand drive shaft
You won't get the stub axle off easily
To replace the stub and the tripod joint will be the same as buying a shaft
You could drill and split pin what you have
quote:
Originally posted by snapper
The push fit hubs are handed
Nearside right hand thread
Offside left hand thread
Both shafts are different lengths
The simple option is to buy a secondhand drive shaft
You won't get the stub axle off easily
To replace the stub and the tripod joint will be the same as buying a shaft
You could drill and split pin what you have
Mine had LHT on the NSR, RHT on OSR, would it not just be easier to buy the correct nut from ford? It sounds to me that what you have is correct.
If you think they are the wrong way around did you swap the ends over when refurbing?
Regards Mark
I didn't do the refurb myself but I don't believe the ends were swapped over as the other side is OK.
Just noticed my reply above... my NSR has a RIGHT hand thread rather than the left hand which it should be.
Sorry , but I've read this thread three times now........and I admit to being confused
What thread do you have on the left of the car , and what thread do you have on the right of the car ?
Nearside: right hand thread
Off-side: right hand thread
So.....whoever re-furbished your driveshafts swapped your OS end for a NS end - can you not just take them back and get them to sort it out ?
quote:
Originally posted by clairetoo
So.....whoever re-furbished your driveshafts swapped your OS end for a NS end - can you not just take them back and get them to sort it out ?