I have a 1.8 pinto sitting in the garage which is surplus to requirements.

Its a 185 block.

Its definately had a new standard cam set fitted (I think its a 2 litre cam but not sure) and was fitted with a new set of rings and bearings (apparently, I dont have receipts to prove it though). Essentially its ready to drop straight in.

Its covered about 2000miles since the new bits were fitted.

Its also fitted with a shortened sump.

The head is off at the moment, so is in a good position to inspect. I will chuck in a complete gasket kit as well so it will be ready to drop back together.

Obviously its collection only

Not sure what its worth TBH, so lets say £80

------------------------------------------

Type 9 cast iron bell housing, cleaned and ready to fit. £15 collected

[Edited on 12/6/09 by flak monkey]

Mmm That bellhousing would be usefull, will u2u u.

wot about the person who was asking about cheap/crap engine yesterday?

this one should fit the bill cost wise.

Who, me?
Got one!

quote:

---

Originally posted by 02GF74
wot about the person who was asking about cheap/crap engine yesterday?

this one should fit the bill cost wise.

---

To add comes complete with electronic dizzy

I'll put som pics up later, bit dusty, but clean inside

Image deleted by owner

Image deleted by owner

Image deleted by owner

Image deleted by owner

[Edited on 12/6/09 by flak monkey]

Going on ebay later today, so open to offers.

David

Now on ebay starting at 99p.....

http://shop.ebay.co.uk/merchant/666devious666

[Edited on 15/6/09 by flak monkey]

Bump, finishes on ebay tomorrow night

Someone got a bargain at £4.85 for the lot....