pair weber 45s 152g 4 proggression holes
60mm ram pipes
38mm chokes
40 pump jets
155 mains
170 air
came off my vx caterham hpc
£340 +p&p
anymore info just ask

Any remote chance you fancy swapping for a set of 40's?? As new condition

no sorry im going over to tbs--well trying too

too much?
how about £320
last pair on flea-bay went for £378

I'm really tempted!
I'm just a little worried about 45's being too much for the fairly standard 2L zetec I have.

Did these run on on the red top? Ie get rid of the stumble?

I take it the intake manifold will have to change as well going from 40's to 45's

Just add what sort of postage money would you be looking at.

To add again! Do they have a linkage or filters or anything with them or just the carbs.

[Edited on 18/4/10 by bigdrew]

[Edited on 18/4/10 by bigdrew]

you would need a inlet manifold with a 45mm bore
stumble?
linkage- comes with the standard spring set up
£10 p&p should cover it, and it ran on my redtop (circa 220bhp)

No problems running 45s on that engine

If you are fitting webers to a zetec you will need to make sure they have 5 progression holes.

If they don't, it will not run right and it is about £100 to have them drilled.

like i said these are off my vx redtop caterham and are 4 proggression hole carbs, don"t know about zetec set-ups.

Why not use the webers as TB's? Just get some injector bosses welded into the inlet manifold.

i was thinking of putting the money from the webers towards some jenveys--got to be the most straight-forward route.
plus ive had an offer to buy

[Edited on 19/4/10 by johnny7]

have photos if anyone intrested before e-bay