Seat Runners £10 + P&P
I believe these came from the back seats of a Renault of some form. I've used one set for my own car and these are spare. Only 25mm high. There is some light surface rust on the outside but run smoothly and includes the cross bar
Description
Expansion Tank SOLD
Bought this from a member on locost builders brand new, fitted it to my car and ran it a few times then decided a would prefer a see through tank so I can see the water level easily (I drive a K series engine tin top so am slightly paranoid about water!!) Has a 12mm right angle fitting on the bottom, 10mm fitting on the front and an overflow port at the rad cap. Approx dimensions 220mm across flanges,120mm high and 115mm deep. Is a bit grubby at the moment but will clean up nicely -
Description
Description
Short Sierra Steering Cowl SOLD
Description
Sierra Brake Balance Reducer £5 + P&P
Description
Sierra Fuel Pump including plunger + spacer £5 + P&P
Description
Ignition Leads £5 + P&P
Brand new Motaquip leads froma Ford KA. Not marked as RFI Surpressed so I swopped them for a set that was. Ideal for and Ford EDIS coilpack setup
Description
Haynes Roadster Wishbone Jig £20 + P&P
This is an Armoto machined wishbone jig. As can be seen, it was used to make my own wishbones for my Haynes roadster so has a few burn marks on it. I have relieved the jig slightly to allow me to use 20mm tubing instead of 19mm - this can be seen by the chamfered edges. Few pics of the jigs in use in Gallery 3 of my pics in my signature.
Description
Description
Cheers
Dave
[Edited on 30/10/12 by davidimurray]
[Edited on 30/10/12 by davidimurray]
[Edited on 30/10/12 by davidimurray]