Zetec coil pack, flywheel, silencer, springs, gauges, etc... Stufffff...
Hello all, having a bit of a garage clear out - all located in Aberdeen up in Bonnie Scotland. I drive down to Knockhill quite regularly so if anybody
wanted to meet me there that would be fine.
Quaife straight cut, synchro gearset and ford motorsport viscous limited slip diff, to suit FWD BC gearbox - will need to be built up into a gearbox -
I can do this for an additional cost - £1,500.
SBD air filter with aluminium back plate to suit SBD Duratec throttle bodies - never fitted as it won't fit on my car - cost £154 new - £100
delivered.
Exhaust silencer, stainless, 6" body, 2-1/4" pipe, 14" long, comes with the two clamps - I cut the body down to size as it was
slightly longer - Probably £20 but would need to get an idea on postage.
![](/galpreviews/) ![](/gallery/)
![](/galpreviews/) ![](/gallery/)
![](/galpreviews/) ![](/gallery/)
2-1/4" coil springs, 450lb/in, 7" long - £15 posted
![](/galpreviews/) ![](/gallery/)
Silvertop Zetec coil pack, can send the HT leads for spares if required - £15 each posted
![](/galpreviews/) ![](/gallery/)
Fiesta ST 150 Duratec sump - Probably £25 posted but will need to get a better idea on postage
![](/galpreviews/) ![](/gallery/)
Wilwood Pull Type Slave Cylinder for converting clutch to hydraulic - £50 posted
![](/galpreviews/) ![](/gallery/)
Fiesta ST150 Duratec flywheel - Probably £40 posted but will need to get a better idea on postage
![](/galpreviews/) ![](/gallery/)
Malpassi Petrol King Regulator For Carburettors - £40 posted
![](/galpreviews/) ![](/gallery/)
![](/galpreviews/) ![](/gallery/)
Dan ST Duratec stainless steel exhaust flange with 1-7/8" port holes - never used - £35 delivered
https://danstengineering.co.uk/index.php?route=product/product&product_id=188&search=duratec
![](/galpreviews/) ![](/gallery/)
Sierra drive hubs / Rear Axle Outer Stub - think this is 100mm / 86mm PCD - £20 posted
![](/galpreviews/) ![](/gallery/)
Westfield rev counter, 80mm - does not have the light holder in the rear for illuminating - £30
![](/galpreviews/) ![](/gallery/)
VDO temperature gauge, 52mm - does not have the light holder in the rear for illuminating - £20
![](/galpreviews/) ![](/gallery/)
Durite oil pressure gauge, 52mm - does not have the light holder in the rear for illuminating - £20
![](/galpreviews/) ![](/gallery/)
Ford Fiesta ST150, Duratec, gearbox - £200
![](/galpreviews/) ![](/gallery/)
Spare wheel carrier for Brian James Minno trailer - £30 delivered
![](/galpreviews/) ![](/gallery/)
1 x rear support stand for Brian James Minno trailer - £15 delivered
![](/galpreviews/) ![](/gallery/)
All items located in Aberdeen in Scotland.
[Edited on 4/11/17 by cosmicicecreamman]
[Edited on 4/11/17 by cosmicicecreamman]
[Edited on 5/11/17 by cosmicicecreamman]
Is this a TRADE ADVERTISEMENT?? Click HERE to report it!
|