I bought some 16mm braided hose on ebay and I also bought some hose finishers too.
The OD of the pipe is 25mm. The finishers I was sent were -16.
They are 31.25mm ID and the other end which is supposed to hold the hose is 28mm.
The seller offered to swap them for -12 finishers, but they are only 24.5mm and the hose won't fit so I am after 6 off -14 finishers which are 28mm ID.
Anyone point me to a good supplier?

Hello martin

Have you tried "Think automotive" in Isleworth.

http://www.thinkauto.com

Cheers for that Bob.
I am sending the hose finishers back.
If -12 fit (which I doubt) they are going to send me a set or refund me.
I have got to ring think auto on Monday as I am after a two way breather (roll over valve) with 8mm ends for a hose from my fuel tank.
I bought a cheap one from ebay but it is 6mm and too short to fit in the hose finisher.