My Roll bar is just a bit too low on the driver's side. Does anyone have a piece of roll hoop i.e. already bent to a radius, going spare that can be welded on top of the existing one? It needs to be about 50mm diam and 100-125mm high.
Thanks, Pewe

I should have something for you.
I will take a pic of it tomorrow and see if it is suitable!

also might have one somewhere if your struggleing

Thanks guys, would appreciate details/pics/sizes. Just checked the existing one and it's 40mm o/d. Cheers, Pewe

[Edited on 23/1/09 by pewe]