Board logo

WTD: 48mm inlet rubbers
vinny1275 - 1/2/09 at 12:01 PM

Hi all,

I'm after some 48mm inlet rubbers, to mount my throttle bodies to the inlet manifold. At the moment I'm using reinforced fuel hose, but the reinforcement means I can't clamp them onto the manifold tightly enough, and they're leaking air.

Anyone have anything? I need them this week as I've got the week off to tune the car!

ETA: or, if anyone can measure some off a bike I can hop off down the bike shop and get some - R1s might be that size...

Thanks,


Vince

[Edited on 1/2/09 by vinny1275]

coozer - 1/2/09 at 12:20 PM

I need four for my CBR1000 bodies... wait for it.. £60 at the bike shop!

vinny1275 - 1/2/09 at 12:21 PM

quote:
Originally posted by coozer
I need four for my CBR1000 bodies... wait for it.. £60 at the bike shop!


the R1 ones are a tenner each, but I need to make sure they're the right internal diameter......

BenB - 1/2/09 at 12:31 PM

Well I can tell you that the ST ones aren't going to be any use. 40mm diameter....

lsdweb - 1/2/09 at 12:36 PM

vinny1275

I've got a set of 48mm ones with clips you can have for a tenner plus postage if you want.

Coozer - I've got a set of 4XV ones - about 44mm ID if they'd be any good to you?

Regards

Wyn

vinny1275 - 1/2/09 at 12:41 PM

Wyn - u2u sent

Cheers


Vince

coozer - 1/2/09 at 03:42 PM

quote:
Originally posted by lsdweb
vinny1275

I've got a set of 48mm ones with clips you can have for a tenner plus postage if you want.

Coozer - I've got a set of 4XV ones - about 44mm ID if they'd be any good to you?

Regards

Wyn


Just checked.. they are 53mm OD! My other set are 62mm