After being a complete @$!@ and messing up the holes on my tunnel cover for the savage switches......

I am after a small piece of carbon fibre or similar approx 10cm x 15cm, beer tokens await anyone who can help

Please help me cover up my @$!@ of a mistake

Best with a close up photo and a ruler to try and match the weave. Lets have a look and maybe we can come up with an alternative solution. Its best to use a piece of card or hardboard to sort the layout on, then transfer that over to the real thing once your happy its ok

I wasn't going to tell what I had done as it is @$$$!@@ stupid!!!!!!!!!

But here goes....

I had marked out both the scuttle and tunnel cover for the switches and clocks. I did the scuttle no problem with the small hole saw and then needed some large holes for the clocks to fit so changed the hole saw....went and made a cup of coffee came out to do the tunnel cover.....can you see where this is going!!! YES - I forgot to change back to the smaller holesaw!!

The holes are now 25mm diameter instead of 22mm, so I just want small piece of carbon to cut out 22mm holes and place over the oversize holes

Edited to add: Tunnel cover is not carbon but Blue with a Black inset top

[Edited on 2/3/09 by spdpug98]

Why not make some nice shiny aluminium bezels to reduce the hole size?

quote:

---

Originally posted by Phil.J
Why not make some nice shiny aluminium bezels to reduce the hole size?

---

Mate, drop round for a brew and a browse, got plenty of off cuts kicking around.....

Ian

Ian

Thanks mate, drop me a u2u with your address and when it's OK, and i'll pop round

Cheers

Dave

quote:

---

Originally posted by iiyama
Mate, drop round for a brew and a browse, got plenty of off cuts kicking around.....

Ian

---

Welcome!