I am fitting a peugeot 206 alloy radiator (after market) that you would have thought was a direct replcement.
If differs by not having tapped hole for sender - gotten around that and maybe size of the mounting lugs.
There are 4 of them, 2 top and 2 bottom, each being 10 mm diameter.
I have 2 ropey ones , don't know what from. (on LH side) 
Went to peugeot dealer and bought 4 206 grommets but these are 13 mm I.D. (RH side)
So peeps, anyone know of which car/model had 10 mm I.D. gormmets?
(Mini ones are 5/16" = 8 mm so too small).
HELP!!!!!!!!!!!!!
Rescued attachment DSC05849.JPG
They look like the ones that came with my polo rad,they are attached to the mouning brackets.
I still have them in the garage,i will check in a bit and if they are the right size you can have them.i only have two though.
Andy
Been in the garage and checked.
I must have used one for something cos i can only find one.
The ID is 12mm and it looks very similar to the one in the right of your pic.
They came from a 1990 polo by the way,if it's any help.
Andy
thanks but 12 mm is too big.
need to go into garage and look ast my collection of rads and fans to try to figure out where the grommet came from
Have you thought of wrapping the lugs in self amalgamating tape to bring them up to size for the pug grommets, or are they too big for the mounting holes?
thought for a moment this was going to be a wrong trousers thread - sorry 
quote:
Originally posted by stevepj
Have you thought of wrapping the lugs in self amalgamating tape to bring them up to size for the pug grommets, or are they too big for the mounting holes?