Board logo

wtd: zx9r back plate rubbers
blakep82 - 13/5/10 at 11:30 AM

does anyone have a spare set of the rubber which hold the filter backplate to the carbs off a zx9r?

mcerd1 - 13/5/10 at 11:31 AM

you need to say they are for the 'E' model carbs (the earlier ones are different)

even then there seem to be 2 kinds

these are the same as my ones linky 1

these are a bit different: linky 2


neather of those say if they are for 1 rubber or the set of 4
but if its for all 4 then thats not a bad price....

[Edited on 13/5/10 by mcerd1]

blakep82 - 13/5/10 at 11:58 AM

sorry yes, E type carbs!

those 2 link, one if for the airbox side, and the other is for the manifold side.

[Edited on 13/5/10 by blakep82]

boggle - 13/5/10 at 11:59 AM

are you putting a real engine in your build now blake?

blakep82 - 13/5/10 at 12:00 PM

quote:
Originally posted by boggle
are you putting a real engine in your build now blake?


thats right, a real car engine, none of your namby pamby hairdrier motors

will get that header drawing done soon barry! promise!

mcerd1 - 13/5/10 at 12:04 PM

quote:
Originally posted by blakep82
those 2 link, one if for the airbox side, and the other is for the manifold side.

that'll be it then - I've never had the ones for the manifold on mine.....

so it'll be these ones you need linky 1

[Edited on 13/5/10 by mcerd1]

blakep82 - 13/5/10 at 12:17 PM

nice one thanks
just emailed to check its for all 4, should be really, title ays rubbers and clips, and shows 4 in the photo